From roberts@pharm1.pharm.sunysb.edu Sat Jan 11 19:35:16 1997 11 Jan 97 22:33:03 +0500 11 Jan 97 22:32:33 +0500 Comments: Authenticated sender is From: "Roy Roberts" Date: Sat, 11 Jan 1997 22:32:47 +0000 MIME-Version: 1.0 Content-type: text/plain; charset=US-ASCII Content-transfer-encoding: 7BIT Priority: normal X-mailer: Pegasus Mail for Windows (v2.30) From: mpeake@alesis1.usa.com (Mike Peake) to: analogue@hyperreal.com Subject: Juno 60 Re-initialization procedure MIME-Version: 1.0 Content-type: text/plain; charset=US-ASCII Content-description: Message Body Content-transfer-encoding: 7BIT Hey Synthgods, Roger Halvorson of Roland USA just gave me the Juno 60 Re-init procedure. Juno-60 - Restoring the factory settings "Original factory data must be loaded in via tape. However there is a memory clearing function that may stop any unusual problems occurring in the unit. (All of the sounds will be erased.) [DID YOU SEE THAT? ERASED! SAVE YOUR SOUNDS TO TAPE FIRST, AND VERIFY THEM!!! EMP] Power off, then make the following settings: Octave Transpose-Norm LFO Trig Mode-Man DCO PWM Mode Switch-Env HPF Cutoff Freq slider-All the way up VCF Env Polarity switch-Down position VCA Control Signal Selector switch-Gate Now, power on while holding down the Chorus Off and 11 buttons." [I'll take it that '11' means 'Chorus 11'. EMP] Roger said he couldn't find re-init info for the 6 and 106. He says it looks like you can load sounds into the 106 to initialize it. The phone number for Roland USA is 213-685-5141. EMPeake "Leaves floors sparkling clean, and your breath minty fresh."