From blw76870@Bayou.UH.EDU Sun Feb 11 17:24:21 1996 11 Feb 96 20:24:15 +0500 9 Feb 96 21:54:53 +0500 Date: Fri, 9 Feb 1996 20:41:04 -0600 (CST) From: Brian Whittington Cc: analogue heaven Subject: Re: quick question > > can a pg-300 be used on anything other than channel 1? i've just gotten > an mks50+pg300 combo (nice!) but without a manual for the pg-300. is > there a hidden way to change the channel, or am i stuck on 1? Set the midi channel according to the table below, using the sub osc level and noise level sliders. Turn off the PG-300, set the sliders, and turn the power on while holding the "manual" button. midi channel 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 sub osc level 0 0 0 0 1 1 1 1 2 2 2 2 3 3 3 3 noise level 0 1 2 3 0 1 2 3 0 1 2 3 0 1 2 3 Regards, Brian From leitner@cs.odu.edu Sun Feb 11 17:20:52 1996 11 Feb 96 20:20:46 +0500 9 Feb 96 15:55:53 +0500 Date: Fri, 9 Feb 1996 15:07:29 -0500 (EST) From: Larry Leitner Cc: analogue heaven Subject: Setting the MIDI Chan on PG-300 To set the MIDI channel on a PG-300 you, 1. Turn PG-300 off. 2. Find the two sliders that have the values 0-3 I think they are the noise, and HPF sliders. 3. Then set them to what channel you want ala binary. 0 - 0 = channel 1 0 - 1 = channel 2 0 - 2 = channel 3 0 - 3 = channel 4 1 - 0 = channel 5 etc... 4. Then while turning the PG-300 on, hold the manual button. Larry ======================================================================== = Larry Leitner leitner@cs.odu.edu WODU AM640 Techno, Trance, Ambient = ======================================================================== ... We are the Robots ...