This cakewalk file has a setup for the faders to program a Sequential
Circuit Six-trak. It is organised very similarly to the figure 7-2 of
the manual, the voice block diagram. There are 11 groups of knobs/sliders
in all, distributed like this:

Top row (knobs):

osc freq: coarse, fine, glide
freq mod: lfo, osc env amount
waveshape: saw, triangle, pulse, pulse width, lfo mod
mode: unison

Second row (knobs):

lfo: frequency, shape, programed amount
mixer: osc/noise
filter: cutoff, resonance, lfo, filter env amount, /\ osc amount, keyboard
amp: voice volume

Bottom row (sliders):

osc env: invert, a, d, s, r
filter env: invert, a, d, s, r
amp: a, d, s, r

These controllers work in all modes (omni on or off, arpegiator, sequencer
etc...) as long as controller receive is enabled (control record-4). This
will make programming much easier. Of course dont forget to save the patch
once you are done, pressing control record, then select the patch number
where you want to write your new patch. If you want to save a patch before
replacing it, you'll have to use a sysex editor of some sort, and once
the program is ready to receive, press control record-2.

Another thing one must not forget: the six-trak will not send it's patch
parameters thru controllers, so the controllers in cakewalk wont reflect
the value in the six-trak until you play with each one of them. However,
you can always set the sliders and knobs to zero and do a patch will all
zero. That way, you'll always start with known values. control record-8
will clear every values in the patch with the exception of sawtooth,
cutoff, keyboard, amp sustain and voice volume (it's called the basic
patch).

Ciao,
--
Francois Dion (IdMEDIA)                   [> Email: francois@hyperreal.com <]
    '                         [> C.P. 278, St-Lambert, QC, Canada, J4P 2N8 <]
        [> Raving Up North Ezine: run-request@hyperreal.com, subject: help <]