From roberts@pharm1.pharm.sunysb.edu Tue Oct 15 15:38:42 1996 15 Oct 96 18:36:55 +0500 15 Oct 96 18:36:32 +0500 Comments: Authenticated sender is From: "Roy Roberts" Date: Tue, 15 Oct 1996 18:38:08 +0000 Subject: Re: sequential pro one Priority: normal > i control my pro one cv gate from a novation basstation. > and have tuning problems. > i cant calibrate my c1 to c6 to be in full tune. > even if i calibrate the c1 from fine tuning,i get insted > of c6 d6,and the way to c6 its out off tune. > the basstation is calibrated to normal cv gate. > there are a few trim screws,but i dont wnow exectly > wich one does what. I don't know about the Basstation but there are some trimpots in the Pro-One that might be of use. It sounds like you have a problem with the scaling -- what you need to do in tune one note and then tune another a couple of octaves away by using the scale adjustment. My Pro-One has three trimpots associated with each VCO: they are to the lower left of the respective frequency knobs. Inside the case they are labeled like this: X offset X high X scale I don't know what the "high" control does but the other two should do what you need. Roy